Cisco ONS 15454 SDH, Руководство по процедурам

Страница: 569 / 860

18-57
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D167 Add a Static TID to NSAP Entry to the TARP Data Cache
Step 3
Click Apply .
Step 4 Return to your originating procedure (NTP).
DLP-D167 Add a Static TID to NSAP Entry to the TARP Data Cache
Step 1 In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 2
Click Add Static Entry .
Step 3 In the Add Static Entry dialog box, enter the following:
•
TID—Enter the TID of the NE. (For ONS nodes, the TID is the Node Name parameter on the node
view Provisioning > General tab.)
•
NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Step 4
Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the
Add Static Entry dialog box.
Step 5 Return to your originating procedure (NTP).
DLP-D168 Remove a Static TID to NSAP Entry from the TARP Data Cache
Step 1
In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 2 Click the static entry that you want to delete.
Step 3
Click Delete Static Entry .
Purpose This task adds a static TID to NSAP entry to the TDC. The static entries are
required for NEs that do not support TARP and are similar to static routes.
For a specific TID, you must force a specific NSAP.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioner or higher
Purpose This task removes a static TID to NSAP entry from the TDC.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioner or higher