Cisco CTS 1000 - TelePresence System 1000 Video Conferencing, Руководство администратора

Страница: 84 / 406

4-12
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 4 Troubleshooting the CTS 500
Managing CTS 500 Hardware Setup
Tip
If you have a pedestal stand-mounted CTS 500 and applied the height sticker, you can use it to choose
an approximate height. For more information about the height sticker, see the
“Assembling a Pedestal
Stand-Mounted CTS 500” chapter in the Cisco TelePresence System 500 Assembly, Use & Care, and
Field Replaceable Unit Guide .
Step 9
Position the easel so the black plus sign (+) of the target is in the same position as the red plus sign

( + ) on the display.
Step 10 Adjust the camera so that the red + is centered on the white target and the hash marks at each side are
aligned to the top of the table.
Tip
You can raise and lower the large target by adjusting the legs of the easel or move the target slightly from
side to side. However, do not move the easel from the position that the user will occupy. If possible, move
the camera to accommodate the position of the easel.
Figure 4-8 shows a camera correctly adjusted.
Figure 4-8 Camera Adjustment
Step 11
Loosen the thumbscrew on the camera and twist the zoom ring on the lens until the curved lines on the
left and right are just touching the left and right borders of the screen. Make sure the black plus sign

(+) is still in the same position as the red plus sign ( + ). Tighten the thumbscrew when the adjustment is
complete.
See Figure 4-8 for an example of correct zoom adjustment.
Step 12
Click Remove Camera Target to stop the test.
205018
Red plus
sign within
black cross
Green
rectangle
Note curved
lines touching
screen border