Cisco CTS 1000 - TelePresence System 1000 Video Conferencing, Руководство администратора

Страница: 272 / 406

8-60
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 8 Troubleshooting the CTS 1300
Managing CTS 1300 Hardware Setup
Or
b. Click Select All to select all ports (and all light units) or Select None.
c.
Click the Refresh On/Off Status button to update the on/off status of each port.
d. Click the Turn Selected Lights On/Off to test the selected light unit(s).
e.
Click the Reset Auxiliary Control Unit to power cycle the Auxiliary Control Unit.
Step 5 Click Stop to end the test.
Verifying CTS 1300 Light Function
Each CTS 1300 has a built-in light fixture. This troubleshooting feature lets you see or change the status
of the light.
To test the light fixture, perform the following procedure:
Step 1 Navigate to Troubleshooting > Hardware Setup.
Step 2 Click the Other Devices radio button.
Step 3
Click the Light tab.
Step 4
Click the Start radio button to begin testing the light. If the light feature is enabled, the Light State On
button is highlighted. If the light feature is disabled, the Light State Off button is highlighted. Click
the Light State On or Light State Off button to change the current state of the light.
Step 5 To end the test, click Stop.
When you end the testing, the state of the light reverts to its default setting as specified in Cisco Unified
Communications Manager.
Digital Media Player
If present on your system, the Digital Media Player (DMP) feature lets you select a secondary audio
input source when you are not in a Cisco TelePresence call.
To test the DMP:
Step 1 Log in to the Cisco TelePresence System Administration interface.
Step 2
Choose Troubleshooting > Hardware Setup.
Step 3 Click the DMP tab.
Step 4
Click Start in the Testing box to begin testing the secondary audio input.
• If you have a PC attached, the Secondary Audio Input Source PC button is highlighted. When
Secondary Audio Input Source is set to PC, the audio input is active while the presentation source
is active, both in and out of a call.
Tip
Setting the DMP to PC in Cisco Unified CM allows you to hear DMP audio.