Cisco CTS 1000 - TelePresence System 1000 Video Conferencing, Руководство администратора

Страница: 178 / 406

7-8
Cisco TelePresence System Administrator Guide
OL-21845-01
Chapter 7 Troubleshooting the CTS 1100
Managing CTS 1100 Hardware Setup
Figure 7-4 Leveling the Camera Assembly
Step 3
Place the small spirit level on the camera and make sure that it is level. Use the rotational (side-to-side)
adjust screws. Use a 3mm Allen wrench for these screws.
Attaching the Large Camera Target to the Easel
To unpack and build the easel and large camera target:
Step 1 Remove the easel, large camera target, and small camera target from their packaging.
Step 2 Unlock and slide the telescoping legs of the easel until the legs are at their full height.
Step 3 Separate the three legs.
Step 4
Raise the front legs until they are 29 inches (74 cm) high.
Step 5 Raise the rear leg until it is 31 inches (79 cm) high.
Step 6
Lock the legs into place using the leg locks.
Step 7 Attach the large camera target to the clip on top of the easel.
Step 8 Raise the target supports on the front legs until they touch the lower part of the large camera target.
Step 9 Raise and lower the front legs until the bottom of the camera target is 32 inches (81 cm) above the
ground.
Level
Camera
rotation
screw
Camera
rotation
screw
206626