Cisco CTS 1000 - TelePresence System 1000 Video Conferencing, Руководство администратора

Страница: 239 / 406

8-27
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 8 Troubleshooting the CTS 1300
Managing CTS 1300 Hardware Setup
Figure 8-23 Positioning the Left Target
Step 2
In the Cisco TelePresence Administration interface, click the Left radio button.
Step 3 Click Show Camera Target.
Step 4
Focus the left camera by completing the following steps:
a. Loosen the focus ring thumbscrew on the lens of the center camera.
b.
Rotate the focus ring until the black plus sign (+) on the target is clearly in focus.
Note
The camera lens has two adjustment rings, one for focus and one for zoom, as shown in
Figure 8-17 . The focus ring is the one that is nearest to the wall.
Step 5
Adjust the camera mounting plate to center the red plus sign ( + ) on the display inside the black plus sign

(+) on the target.
Figure 8-19 shows the screws that you use to adjust the camera. Use a 2.5 mm Allen wrench.
•
Use the top two screws for left and right adjustment.
• The lower screw for up and down adjustment.
•
The screws in the middle for adjustments on the horizontal plane (rotational).
Step 6 Adjust the camera zoom by completing the following steps:
a.
Loosen the thumbscrew for the zoom ring on the camera lens.
Note
The zoom ring is labeled “W-T.”
b.
Adjust the camera zoom so that the black curved line on the left of the target touches the left edge
of the display screen, as shown in
Figure 8-24 .
c. After you adjust the zoom, make any required adjustments to the focus with the focus ring.
Left participant
sitting position
camera target
Display
206144
Alignment
marker