Cisco CTS 1000 - TelePresence System 1000 Video Conferencing, Руководство администратора

Страница: 345 / 406

10-11
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 10 Troubleshooting the CTS 3010 and CTS 3210
Managing CTS 3010 and CTS 3210 Hardware Setup
d.
Place the small target on the table in front of the large target, and adjust the focus by completing the
steps in the
“Focusing the Camera” section on page 10-12 .
e. Remove the large target from the center part of the table, and attach it to the left part of the table,
placing the underside of the clamps into the recessed holes.
f.
Make manual adjustments to the camera focused on the target and the zoom ring on the camera to
make the following adjustments to the camera:
• Align the red plus sign to the plus sign in the middle of the target.
•
Align the red hash marks on the display so that they fit between the table edges.
• Zoom and align the camera so that the curved line on the right side of the display touches the
red adjustment line at the right edge of the display as shown in
Figure 10-6 .
Tip
To adjust the camera left and right or up and down, or to make vertical adjustments, use the
adjusting screws as shown in
Figure 10-4 .


If one of the left/right screws is covered by the camera cable, use the other screw to make all
left/right adjustments.
Figure 10-6 Correct Camera Target Alignment—Right Display
g.
Place the small target on the table, in front of the large target, and adjust the focus by completing
the steps in the
“Focusing the Camera” section on page 10-12 .
h. Remove the large target from the center part of the table, and attach it to the right part of the table,
placing the underside of the clamps into the recessed holes.
i.
Make manual adjustments to the camera focused on the target and the zoom ring on the camera to
make the following adjustments to the camera:
• Align the red plus sign to the plus sign in the middle of the target.
•
Align the red hash marks on the display so that they fit between the table edges.
• Zoom and align the camera so that the curved line on the left side of the display touches the red
adjustment line at the right edge of the display
Figure 10-7 .
Red plus
sign within
black cross
Red lines
Table
edge
Red
Vertical line
205765