Cisco CTS 1000 - TelePresence System 1000 Video Conferencing, Руководство администратора

Страница: 361 / 406

10-27
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 10 Troubleshooting the CTS 3010 and CTS 3210
Managing CTS 3010 and CTS 3210 Hardware Setup
Checking the VGA
To check the VGA on the CTS 3010 or CTS 3210:
Step 1
Log in to the Cisco TelePresence System Administration interface.
Step 2
Choose Troubleshooting > Hardware Setup.
Step 3 Click the Presentation Devices radio button.
Step 4 Click Start in the Testing box. The Presentation Source buttons are activated.
Step 5 Select VGA and click Test. It may take up to 15 seconds before you begin to see an image on the
projection surface. The image should be fully formed after approximately 45 seconds.
If the input image is displaying correctly, you should see an image projected on the projection surface.
If the image is out of focus, use the projector focus ring to focus the image.
Step 6
Click Stop Test to end the test.
Step 7
Click Set Projector Defaults to reset the projector to the default settings.
Step 8 Click Stop in the Testing box to end all testing.