Cisco CTS 1000 - TelePresence System 1000 Video Conferencing, Руководство администратора

Страница: 223 / 406

8-11
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 8 Troubleshooting the CTS 1300
Managing CTS 1300 Hardware Setup
Figure 8-6 Camera Rotational Adjustment Screws
Attaching the Large Camera Target to the Easel
To unpack and build the easel and large camera target:
Step 1 Remove the easel, large camera target, and small camera target from their packaging.
Step 2
Unlock and slide the telescoping legs of the easel until the legs are at their full height.
Step 3 Separate the three legs.
Step 4 Raise the front legs until they are 29 inches (74 cm) high.
Step 5 Raise the rear leg until it is 31 inches (79 cm) high.
Step 6
Lock the legs into place using the leg locks.
Step 7 Attach the large camera target to the clip on top of the easel.
Step 8
Raise the target supports on the front legs until they touch the lower part of the large camera target.
Step 9 Raise and lower the front legs until the bottom of the camera target is 32 inches above the ground.
Figure 8-7 shows the completed camera target and easel.
Right
adjust
screw
Left
adjust
screw
Up/down
adjust
screw
Side to side
adjust screw
Side to side
adjust screw
Up/down
adjust
screw
206130