Cisco CTS 1000 - TelePresence System 1000 Video Conferencing, Руководство администратора

Страница: 46 / 406

3-2
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 3 Configuring the Cisco TelePresence System
First Time Setup for All Other CTS Models
First Time Setup for All Other CTS Models
To set up your Cisco TelePresence System (CTS) for the first time, you must first load the CTS
Administration software and bootup the system.
This section contains the following information:
• Loading CTS Administration Software, page 3-2
•
Logging In To the Cisco TelePresence System Administration Interface Directly, page 3-3
• Configuring a Static IP Address for Networks That Do Not Use DHCP, page 3-4
•
Configuring an Alternate TFTP Server (Optional), page 3-7
• Configuring Your System After Initial Bootup, page 3-7
Loading CTS Administration Software
CTS Administration Software is factory-installed on each codec and loads during initial bootup. To boot
up CTS Administration Software:
Step 1
Power on the PDU that is on the bottom of the CTS cabinet by turning the switch to the On position.
Step 2 Turn on the codecs that are associated with your CTS device. The displays associated with each codec
become active. CTS displays green check marks on all displays to show bootup progress. Bootup is
complete when the system displays six check marks, as shown in
Figure 3-1 .
Tip
Ignore any messages that indicate a communication error with the camera; this message indicates that
the system has not yet downloaded the correct software or firmware.
Figure 3-1 Bootup Completed