Cisco CTS 1000 - TelePresence System 1000 Video Conferencing, Руководство администратора

Страница: 291 / 406

9-7
Cisco TelePresence System Administration Guide
OL-21845-01
Chapter 9 Troubleshooting the CTS 3000 and CTS 3200
Managing CTS 3000 and CTS 3200 Hardware Setup
Testing Cameras
The cameras are set up successfully when images are centered and in focus on the display screens and
the white balance has been configured. The hardware setup software provides a camera Auto Adjust
feature and a way to use targets to fine-tune the camera’s focus.
Note You must use the camera Auto Adjust feature before you can auto focus the camera. See the “Auto
Adjusting the Camera” section on page 9-8 .
Use the information in the following sections to test and troubleshoot the camera for your system:
•
Testing the CTS 3000 and CTS 3200 Cameras, page 9-7
• Troubleshooting Cameras, page 9-14
•
Related Information, page 9-15
Note
The camera hood comes off. It should be removed and left off until these procedures are complete.
Testing the CTS 3000 and CTS 3200 Cameras
The cameras are set up correctly when images are centered and in focus on the display screens and the
white balance has been configured. The hardware setup software provides a camera Auto Adjust feature
and a way to use targets to fine-tune the camera’s focus.
The following sections describe how to set up the CTS 3000 and CTS 3200 cameras for testing:
• Attaching the Camera Targets and Removing the Camera Cover, page 9-7
• Testing the Camera, page 9-8
• Auto Adjusting the Camera, page 9-8
•
Aligning the Camera, page 9-8
• Showing All Camera Targets, page 9-11
•
Focusing the Camera, page 9-11
• Saving Your Settings, page 9-12
• Attaching the Camera Hood Assembly, page 9-12
Attaching the Camera Targets and Removing the Camera Cover
Two camera targets are provided with the Cisco TelePresence system:
•
Large camera target
• Smaller target
To attach the targets:
Step 1
Attach the large camera target to the table with the clamps matching the counterbore feature under the
table.
Step 2 Center the target on the edge of the table and position it vertically with the clamps underneath the table
holding it tight. The target pattern should face the camera.