Campbell CR3000 Micrologger, Руководство оператора

Страница: 46 / 644

Section 4. Quickstart
46
PC200W EZSetup Wizard Prompts
Screen Name Information Needed
Datalogger Settings
Configures how the CR3000 communicates with
the PC.
For this tutorial, accept the default settings.
Datalogger Settings —
Security For this tutorial, Security Code should be set to 0
and PakBus Encryption Key should be left blank.
Communication Setup
Summary
Summary of settings in previous screens. No
changes are needed for this tutorial. Press Finish to
exit the wizard.
4.6.4 Write CRBasic Program with Short Cut
Following are the objectives for this Short Cut programming exercise:
•
Create a program to measure the voltage of the CR3000 power supply,
temperature of the CR3000 wiring panel, and ambient air temperature
using a thermocouple.
•
When the program is downloaded to the CR3000, it will take samples
once per second and store averages of the samples at one-minute
intervals.
NOTE A video tutorial is available at
https://www.campbellsci.com/videos?video=80
https://www.campbellsci.com/videos?video=80. Other video resources
are available at www.campbellsci.com/videos.
4.6.4.1 Procedure: (Short Cut Steps 1 to 5)
1. Click on the Short Cut icon in the upper-right corner of the PC200W window.
The icon resembles a clock face.
2. The Short Cut window is shown. Click New Program.
3. In the Datalogger Model drop-down list, select CR3000.
4. In the Scan Interval box, enter 1 and select Seconds in the drop-down list
box. Click Next.
Note The first time Short Cut is run, a prompt will appear asking for a
choice of ac noise rejection. Select 60 Hz for the United States and other
areas using 60 Hz ac voltage. Select 50 Hz for most of Europe and other
areas that operate at 50 Hz. A second prompt lists sensor support options.
Campbell Scientific, Inc. (US) is probably the best fit if you are outside
Europe.