Bullhorn RM2000 Series, Руководство по установке и настройке

Страница: 50 / 82

RM2000 Series Installation and Configuration Guide
42 RM2000 Series Configuration
6 Complete one of the following steps to reset the accumulated count to zero:
a Type a value in the Accumulator Reset Value field if you want to reset
the count to zero (0) when channel 5 reaches a certain value.
–or–
b Click Reset on Low Alt Channel to have the accumulator reset to zero
(0) when a low/closed state occurs on channel 6.
–or–
c Click Reset on High Alt Channel to have the accumulator reset to zero
(0) when an a high/open state occurs on channel 6.
7 If channel 5 is set up in Active Digital mode, complete the following steps
to set up channel alarms:
a Click Transmit Low Alarm to have an alarm transmitted when the
input voltage is lower than the threshold value.
b Click Transmit High Alarm to have an alarm transmitted when the
input voltage is higher than the threshold value.
8 If channel 5 is set up in Digital Dry Contact mode, complete the following
steps to set up channel alarms:
a Click Transmit Closed Alarm to have an alarm transmitted when the
input device is in a closed state.
b Click Transmit Open Alarm to have an alarm transmitted when the
input device is in a open state.
9 If channel 5 is set up in Digital mode, complete the following steps to set
up channel alarms:
a Click Transmit Low Alarm to have an alarm transmitted when the
input device is in a closed state.
b Click Transmit High Alarm to have an alarm transmitted when the
input device is in a open state.
c Click Repeat Low Alarm to continue transmitting low alarms until the
alarm condition is removed.
10 Click Validate/Check Entries to verify configuration settings are correct
and then click Save .