Bullhorn RM2000 Series, Руководство по установке и настройке

Страница: 33 / 82

RM2000 Series Installation and Configuration Guide
RM2020 Installation 25
I
MPORTANT
:
Install the solar panel at least two (2) feet below the
antenna to help prevent the solar panel from interfering with data
transmissions.
3 Connect the solar panel cable to the water-tight fitting on the bottom of the
enclosure.
Establish Communications with ORBCOMM Satellite
Complete the following steps:
1 Open the enclosure to connect the configuration cable in the USB Config
port on the faceplate of the RM2020 (Figure 2-1). Depending on the type of
configuration cable, connect the other end of the cable in an available USB
or RS232 serial port on your computer.
2 Turn ON the RM2020 power switch (Figure 2-1).
3 Start the UCT software. When the
Find Devices
window displays, select
your RM2020.
N
OTE
:
The UCT software begins to initialize. If the battery voltage is too
low for normal operations, the status bar will freeze and the initialization
process will not continue. Either recharge or replace the battery to
continue.
4 Click Auto Update in the
Communications
group box when the main
configuration window displays.
5 View the
RADIO LED
on the faceplate of the RM2020 (Figure 2-1) to
confirm the unit is communicating with the ORBCOMM satellite. The LED
is red when acquiring a satellite signal and then turns green when
communication has been established.