Bullhorn RM2000 Series, Руководство по установке и настройке

Страница: 26 / 82

RM2000 Series Installation and Configuration Guide
18 RM2020 Installation
Installation Overview
The following steps provide an overview of a typical installation. The information
also identifies the recommended installation sequence.
1 Determine where to install RM2020, making sure objects or the terrain do
not interfere with satellite communication.
2 Mount the enclosure; install the antenna/surge arrestor; install the solar
panel battery charger.
3 Connect the configuration cable in the USB CONFIG port of the RM2020.
Connect the other end of the cable in a USB port on your computer.
4 Turn ON the RM2020 power switch.
5 Run the UCT software to establish a communication link with the
ORBCOMM satellite.
6 Connect the solar panel battery charger cable in the connector on the
bottom of the RM2020 enclosure.
7 Connect your device(s) to RM2020 input channels and dress input wires
inside the enclosure.
8 Connect a ground wire to the ground lug on the antenna/surge arrestor.
9 Connect RM2020 input wires to output terminals of your device(s).
10 Configure RM2020 for service using UCT software.
I
MPORTANT
:
Electrostatic Discharge (ESD) can damage electronic
components. Provide ESD protection by wearing an antistatic wrist strap attached
to any unpainted metal surface before opening the enclosure door of the unit or
handling electronic parts. If an antistatic wrist strap is unavailable, discharge
static electricity from yourself and your clothing by touching a nearby metal
surface before opening the enclosure door of the unit or handling electronic
components.