Bullhorn RM2000 Series, Руководство по установке и настройке

Страница: 42 / 82

RM2000 Series Installation and Configuration Guide
34 RM2000 Series Configuration
2 Select a field in the Transmit report at field. Use the up and down arrows
to adjust the time. Repeat this step for remaining time fields as needed.
3 If you want to include a delay in the transmission schedule, click Add
Delay to place a check mark in the check box.
N
OTE
:
Add Delay is based on the unit serial number. The unit serial
number is equivalent to the number of seconds added to the reporting
time. This feature is typically used to offset the transmission schedule for
several units set up with the same reporting time.
4 Choose a repeat interval option in the And repeat every drop-down list.
5 Click Save .
Set Up Input Channels and Alarms
Based on the type of input device connected to the input channels of the unit, use
the procedures in the following sections to set up channels and alarms.

Set Up an Input Channel for Millivolt Readings (page 34)

Set Up an Input Channel for Analog Readings (page 37)

Set Up an Input Channel for Digital Readings (page 39)

Set Up Channel 5 for Accumulator Readings (page 41)
Set Up an Input Channel for Millivolt Readings
Channels 1, 3, and 4 on the RM2020 support a millivolt input device in a range of
±5V. Channel 2 supports ±100V.
Complete the following steps to set up channels 1, 3, or 4 for millivolt readings.
Refer to the Glossary on page 59 for UCT field descriptions.
1 Based on the input channel the input device is connected to, click CH1 ,
CH3 , or CH4 to display the channel configuration window (Figure 3-3).
For example, click CH1 if the input device is connected to input channel 1
of the unit. Unit input channels 1, 3, and 4 support a millivolt device (such
as a rectifier shunt) in a range of ±5V.