Bullhorn RM2000 Series, Руководство по установке и настройке

Страница: 45 / 82

RM2000 Series Installation and Configuration Guide
RM2000 Series Configuration 37
Set Up an Input Channel for Analog Readings
Complete the following steps to set up Channels 1, 2, 3, or 4 in analog mode. Refer
to the Glossary on page 59 for UCT field descriptions.
1 Based on the input channel the input device is connected to, click CH1 ,
CH2 , CH3 , or CH4 to display the channel configuration window (Figure 3-
4).
For example, click CH2 if the input device is connected to input channel 2
of the unit. Unit input channels 1, 2, 3, and 4 support ±5V with channel 2
also supporting ±100V.
Figure 3-4. Example of Channel 2 (CH2) Analog Settings
2 Click Enable and Analog to enable the channel for service and analog
mode.
3 Click +/– 5V or +/– 100V if the input device has a voltage output of ±5VDC
or ±100VDC, respectively.
4 Type the unit of measurement used by the input device in the Engineering
Units (on transducer) field.