Bullhorn RM2000 Series, Руководство по установке и настройке

Страница: 27 / 82

RM2000 Series Installation and Configuration Guide
RM2020 Installation 19
Mounting the Enclosure
The following sections explain how to mount the RM2020 enclosure (Figure 2-2)
on different types of surfaces. The unit’s enclosure includes a factory-installed
bracket for mounting on a pole or flat surface (Figure 2-3).
Figure 2-3. Mounting Bracket
Mounting the Enclosure on a Metal Pole or Pipe
The enclosure comes with a pole mounting kit that includes two (2) u-bolts, two
(2) pipe brackets, and mounting hardware (4 nuts and washers for the u-bolts).
The typical installation is on a free-standing metal pole or pipe using the included
u-bolt kit to attach the enclosure to the pole or pipe.
To install the RM2020 enclosure on a metal pole or pipe, complete the following
steps:
1
Run one u-bolt around the pole, through the pipe bracket, and then
through the top of the mounting bracket. See Figure 2-3.
2
Slide a washer over and thread a nut onto each end of the u-bolt and
tighten each nut.
3
Repeat steps
1
and
2
for the bottom of the mounting bracket.
4
Continue with Installing the Antenna/Surge Arrestor on page 21.