Bullhorn RM2000 Series, Руководство по установке и настройке

Страница: 48 / 82

RM2000 Series Installation and Configuration Guide
40 RM2000 Series Configuration
2 Click Enable to enable the channel for service.
3 Click Active Digital or Digital Dry Contact . Only channels 5 and 6 support
Digital Dry Contact mode.
4 If you want to include an optional Debounce filter in alarm settings, type
the number of seconds the input channel must remain in an alarm state
before the unit transmits an alarm packet. If you want alarm states
recognized immediately, enter zero (0) in the field.
5 If the channel is set up in Active Digital mode , complete the following
steps to set up channel alarms:
a Click Transmit Low Alarm to have an alarm transmitted when the
input voltage is lower than the threshold value.
b Click Transmit High Alarm to have an alarm transmitted when the
input voltage is higher than the threshold value.
6 If channel 5 or 6 is set up in Digital Dry Contact mode , complete the
following steps to set up channel alarms:
a Click Transmit Closed Alarm to have an alarm transmitted when the
input device is in a closed state.
b Click Transmit Open Alarm to have an alarm transmitted when the
input device is in a open state.
7 Click Validate/Check Entries to verify configuration settings are correct
and then click Save .
Text boxes display green or red to indicate whether or not an entered value
is correct. If a text box is red, enter a different value and then validate
again. If all text boxes are green, settings are correct.