Bullhorn RM2000 Series, Руководство по установке и настройке

Страница: 12 / 82

RM2000 Series Installation and Configuration Guide
4 Getting Started
The flexibility of the Bullhorn unit enables it to monitor various types of devices
such as cathodic protection rectifiers, test points, critical bonds, tanks, and meters.
After installing the unit, you then configure it for service using the Universal
Configuration Toolkit (UCT) software. The UCT software allows you to set
specific parameters that enable the unit to report measurements, alarm
conditions, state changes, health check intervals, and accumulated counts.
Required Equipment
The following items are required to install and configure the unit types included
in the RM2000 Series:

Small slotted screwdriver

Small Phillips head screwdriver

Wire stripper

Wire cutter

Voltmeter

Adjustable wrench if installing the solar panel battery charger

Socket or open end wrench set

Satellite terminal (provided in the installation kit)

Compass

Waterproof sealing tape

Non-conductive silicon grease (provided in the installation kit)

Satellite terminal interface cable (provided in the installation kit)

Silicon adhesive

Mounting hardware appropriate for the type of mounting surface
(supplied by customer)

Appropriate tools to prepare the mounting surface for the installation.
Depending on the mounting surface, this may include a hand drill and
metal, masonry, or wood drilling bit.

Configuration cable (provided in the installation kit):
• RS232 serial configuration cable
•
Mini USB cable

Installation drawing (provided in the installation kit)