BLEMO ER40-G, Руководство по программированию

Страница: 155 / 242

155
[1.7 APPLICATION FUNCT.] (FUn-)
(1) The parameter can also be accessed in the [1.3 SETTINGS] (SEt-) menu.
Code Name/Description Adjustment range Factory setting
tOL-
•
[TORQUE LIMITATION]
This function cannot be accessed in V/F profile mode.
tLA
• [Torque limit. activ.]
[No] (nO)
nO
YES
LI1
-
-
-
-
[No]
(nO) : Function inactive
-
[Yes]
(YES) : Function always active
-
[LI1]
(LI1)
:
:
-
[...]
(...) : See the assignment conditions on page 109 .
If the assigned input or bit is at 0, the function is inactive.
If the assigned input or bit is at 1, the function is active.
tLIM
• [Motoring torque lim]
(1) 0 to 300% 100%
The parameter cannot be accessed if [Torque limit. activ.] (tLA) = [No] (nO)
Torque limitation in motor mode, as a % of the rated torque.
tLIG
• [Gen. torque lim]
(1) 0 to 300% 100%
The parameter cannot be accessed if [Torque limit. activ.] (tLA) = [No] (nO)
Torque limitation in generator mode, as a % of the rated torque.
tAA
• [Torque ref. assign.]
[No] (nO)
nO
AI1
-
AI4
PI
PG
-
[No]
(nO) : Not assigned (function inactive)
-
[AI1]
(AI1)
to
[AI4]
(AI4) : Analog input, if VW3A3202 I/O card has been inserted
-
[RP]
(PI) : Frequency input, if VW3A3202 I/O card has been inserted
-
[Encoder]
(PG) : Encoder input, if encoder card has been inserted
If the function is assigned, the limitation varies between 0% and 300% of the rated torque on the basis of
the 0% to 100% signal applied to the assigned input.
Examples:
- 12 mA on a 4-20 mA input results in limitation to 150% of the rated torque.
- 2.5 V on a 10 V input results in 75% of the rated torque.
tLC • [Analog limit. act.]
[Yes] (YES)
YES
LI1
-
-
-
The parameter can be accessed if [Torque ref. assign.] (tAA) is not [No] (nO) .
-
[Yes]
(YES) : The limitation depends on the input assigned by [Torque ref. assign.] (tAA) .
-
[LI1]
(LI1)
:
:
-
[...]
(...) : See the assignment conditions on page 109 .
If the assigned input or bit is at 0:
• The limit is specified by the
[Motoring torque lim] (tLIM) and [Gen. torque lim] (tLIG) parameters if
[Torque limit. activ.] (tLA) is not [No] (nO) .
• No limitation if [Torque limit. activ.] (tLA) = [No] (nO) .
If the assigned input or bit is at 1:
• The limitation depends on the input assigned by
[Torque ref. assign.] (tAA) .
Note: If [Torque limitation] (tLA) and [Torque ref. assign.] (tAA) are enabled at the same time, the lowest
value will be taken into account.
Parameter that can be modified during operation or when stopped.