BinTec X4000, Руководство пользователя

Страница: 72 / 498

72 X4000 User’s Guide
Configuration Requirements
4
If you use the Configuration Wizard for configuration, you also connect to X4000
over the serial interface, but you do not access the SNMP shell. The start
window of the Configuration Wizard appears in this case (see Figure 6-1,
page 113 ).
Unix If you are using a Unix PC, you cannot use HyperTerminal. You will require a
terminal program such as cu (under System V), tip (under BSD) or minicom
(under Linux). The settings for these programs are the same as listed above.
Example of a command line for using cu:
cu -s 9600 -c/dev/ttyb
Example of a command line for using tip:
tip -9600 /dev/ttyb
If the login prompt does not appear after pressing Return several times, the
connection to
X4000 has not been set up successfully. Check the COM1 or
COM2 settings on your PC.
➤
Click File
➧
Properties.
➤
Click Configure.... in the Connect to tab.
The following settings are necessary:
– Bits per second: 9600
– Data bits: 8
– Parity: none
– Stop bits: 1
– Flow control: none
➤
Enter the values and click OK.
➤
Set in the Settings tab:
– Emulation: VT100
➤
Click OK.
The changes to the terminal program settings do not take effect until you
disconnect the connection to
X4000 and set up the connection again.
You can also use any other terminal program that can be set to 9600 bps, 8N1
(8 data bits, no parity, 1 stop bit), software handshake (none) and VT100
emulation.