BinTec X4000, Руководство пользователя

Страница: 416 / 498

416 X4000 User’s Guide
Important Commands
14
–
address
: X4000 ’s IP address for the interface (ipRouteNextHop).
–
netmask <mask>
: netmask of the interface (ipRouteMask).
–
up
: sets the interface to the up status.
–
down
: sets the interface to the down status.
–
dialup
: sets the interface to the dialup status.
–
-
: does not define its own IP address (ipRouteNextHop = 0.0.0.0).
–
metric <n>
: sets route metric to n (ipRouteMetric1).
ifstat
ifstat [-lur] [<ifcname>]
Is used to display status information for the system’s interfaces, based on the
contents of the MIB table ifTable.
–
-l
: displays the full length of the interface information (normally the
information is only displayed up to the twelfth character).
–
-u
: only displays information on interfaces that are in the up status.
–
-r
: displays the filters defined for the interface.
–
ifcname
: only displays information on interfaces whose names start
with the characters entered (e.g.
ifstat en1
will display information
on the interfaces en1, en1-IIc and en1-snap).
netstat
netstat [[-i | -r | -p [<interface>]] | -d <dest. IP addr.>]
Is used to display a short list of system information.
–
-i
: displays a list of the interfaces.
–
-r:
displays a list of routing table entries.
–
-p
: displays a list of WAN partners.
–
interface
: limits the information displayed to the selected interface.
–
-d <dest. IP addr.>
: displays routes to the IP address entered.
date
date [YYMMDDHHMMSS]
X4000 has a software clock. Entering
date
displays the time set.