BinTec X4000, Руководство пользователя

Страница: 137 / 498

X4000 User’s Guide 137
Configuring WAN Interfaces
7
7.2 Configuring WAN Interfaces
The necessary steps for configuring the WAN interfaces of X4000 are described
below step by step.
The basic unit is equipped with the following WAN interfaces:
■
ISDN BRI interface (see chapter 7.2.1, page 137 )
■
Two serial interfaces: X.21/V.35/V.36 interface and X.21bis interface (see
chapter 7.2.2, page 148 )
ADSL
■
You can also configure the LAN interface as an interface to the WAN by
providing a connection to T-DSL, the ADSL connection of Deutsche
Telekom, using PPP-over-Ethernet (see chapter 7.2.3, page 155 ).
If you use a LAN expansion card, see chapter 9.3.2, page 288 .
Installing an expansion card enables other WAN interfaces to be used on
X4000 , if applicable (see chapter 9, page 277 ).
7.2.1 Configuring the ISDN BRI Interface
You can use the ISDN BRI interface of X4000 for both dialup and leased lines
over ISDN.
Proceed as follows to configure the ISDN BRI interface:
■
Entering the settings of your ISDN connection:
Here you set the most important parameters of your ISDN connection.
■
Configuring Incoming Call Answering:
Here you tell X4000 how to react to incoming calls from the WAN.
Autoconfiguration,
ISDN Switch Type, …
Firstly, enter the settings for your ISDN connection.
➤
Go to CM-1BRI, ISDN S0: