BinTec X4000, Руководство пользователя

Страница: 209 / 498

X4000 User’s Guide 209
Settings Specific to WAN Partners
8
For X4000 , the X.25 software is designed as an X.25 switch. This switch must
be appropriately configured for AO/DI (see "X.25 configuration", page 209 ).
You will find all the necessary steps below for configuring X4000 for AO/DI with
the Setup Tool.
X.31 configuration Proceed as follows to assign X.31/X.25:
➤
Go to CM-1BRI, ISDN S0
➧
A
DVANCED
S
ETTINGS
(the menu is described
in chapter 8.1.4, page 197 ).
➤
Select X.31 TEI Value:
specify.
➤
Enter Specify TEI Value:
1.
➤
Select X.31 TEI Service: Packet Switch.
➤
Press SAVE.
You have returned to the CM-1BRI, ISDN S0 menu.
➤
Press SAVE.
You have returned to the main menu. The main menu now contains the
X.25 menu, which you need for the following configuration steps.
Information about the X.25 parameters can be found in the Extended
Features Reference at www.bintec.de .
X.25 configuration Proceed as follows to make the preset link settings for X.25 configuration for
Datex-P:
➤
Go to X.25
➧
L
INK
C
ONFIGURATION
.
➤
Select the interface for which you want to configure X.25, e.g. x31d2-0-1.
The default setting for X.31 TEI Value should be specify. If this is not the case,
the X.31 service has not been detected by autoconfiguration and this service is
probably not supported (contact your telephone provider).