BENSHAW RSi GX Series, Руководство по оборудованию

Страница: 47 / 168

4.2.4 Monitoring of Operation Status
•
Output current display
Monitoring output current in Drive group.
•
Fault display
•
How to monitor fault condition in Drive group
The fault type is displayed at the DRV group when a fault occurs, and the frequency,
current, operating status (accelerating, decelerating, in constant speeds) can be monitored
by using the UP, DOWN key. (Ex: Fault occurred when the drive was accelerating at 40.28
Hz, 20.5A) 4 LED is blinking in this situation. Fault status can be removed by using the
STOP/RESET key, and the LED turns off. (The drive must be turned OFF and turned ON
again to remove HW fault status.) When more than one fault occurs at the same time the
information can only be displayed for a maximum of three faults.
41
4 - Operation
1
In [0.0], continue pressing the Up (
p
) or Down (
q
) key until [CUr] is
displayed.
2
Monitoring output current is provided in this parameter.
Press the Enter (
˜
) key once to check the current.
3
Present output current is 5 A.
Press the Enter (
˜
) key once to return to the parameter name.
4
Return to the output current monitoring code.
z
Note:
Other parameters in Drive group such as dCL (Drive DC link current) or vOL (Drive
output voltage) can be monitored via the same method.
0.00
CUr
5.00
CUr
1
This message appears when an Overcurrent fault occurs.
Press the Enter (
˜
) key or UP/Down key once.
2
The run frequency at the time of fault (30.0) is displayed.
Press the Up (
p
) key once.
3
The output current at the time of fault is displayed.
Press the Up (
p
) key once.
4
Operating status is displayed. A fault occurred during acceleration.
Press the STOP/RST key once.
5
A fault condition is cleared and “nOn” is displayed.
OCt
30.00
5.0
ACC
nOn