Barco Event Master E2 Series, Руководство пользователя

Страница: 116 / 584

R5905948 /12 Event Master Devices 116
Description
Image 6-14: Configuration Menu: System modifier area
• Canvas Mode : Canvas mode allows the user to choose between “ PGM and PVW ” canvas mode (the
default setting) and “ PGM only ” canvas mode.
- PGM and PVW — (Default) The unit reserves up to 20 megapixels of canvas for Preview (PVW) and for
Program (PGM) whenever a Screen Destination is created.
The preview canvas allows the user to preview changes before those changes are output to a Screen
Destination.
- PGM only —” PGM only ” mode doubles the amount of PGM canvas to 40 megapixels, because the unit
no longer reserves canvas for PVW.
◦ Because the system no longer maintains a preview canvas, Backgrounds will cut to the program
canvas (PGM). Mixing layers, however, will still mix between sources.
◦ The Chroma key feature is not available in “ PGM only ” mode. (The Luma key feature is available in
“ PGM only ” mode.)
After updating the canvas mode, save the configuration by pressing the "Save All" button at the bottom
of the Menu navigation bar (on the left-hand edge of the screen), and then soft reset / power cycle the
unit for the system to reconfigure the VPU cards.
Note: The maximum number of canvas links available for the Multiviewer is eight for the E2, and four
for the S3.
• Preset Conflict: Mode — When using single layers conflicts can arise when a Preset Recall modifies a
source layer that is currently on Program. You may choose from three Preset Conflict Modes to resolve
these conflicts.
- Auto — The system performs the necessary actions to gracefully recall the Preset to Preview and to
wait for the user to transition to Program.
- Force Recall — The system recalls the Preset directly to Program. Program is not protected.
- User Confirm — The system presents the user with a pop-up asking what to do when a conflict is
detected.
User Confirm options:
◦ Resolve – All Trans or Cut: Perform the necessary actions to resolve the conflict and perform an
All Trans or Cut to bring the Preset to Program.
◦ Resolve – Wait: Perform the necessary actions to resolve the conflict and wait for the user to press
the All Trans or Cut manually.
◦ Cancel: Cancels the entire Preset recall operation.
- Off — The system alerts the user with an error message about any Preset recall conflict, but it does not
present a pop-up menu for resolving the issue.
• Preset Conflict: Time(frame) is the amount of time the system uses when automatically performing an All
Trans.
• System Native Rate (Hz) : System native rate in Hz (Cycles in second). Available selections:
23.98 30 59.94 120
24 47.95 60
25 48 100
29.97 50 119.88
The native system rate needs to match the general frame rate in the event where the unit is used.
• System Backup : IP address of the backup system.
Enter the IP address of the backup unit, and press the "Sync" button to push the settings from the active
system to the backup system.
• Genlock : Selects the system genlock mode from the options Freerun , Lock to External , or Lock to Unit
ID .
• Genlock Status : Reports the system ’ s genlock mode status: Locked or not Locked.
EM GUI orientation