Barco Event Master E2 Series, Руководство пользователя

Страница: 364 / 584

R5905948 /12 Event Master Devices 364
Recalls the mapped CUE for “ Play/Pause ” and “ Stop ” actions.
BG Source (Green)
Places the mapped BG to the selected Destination.
If LIVE mode is activated the above actions happen to the Program instead of the Preview.
12.8 How to use the page arrow buttons
General
Each row of Assign buttons has a display that shows the active page and up and down arrow buttons that
are used to change pages.
Up and down increase or decrease the page number.
The controllers allow for many pages of each function type to be assigned. The following two-key
combinations allow the user to change pages in larger increments (jumps).
1. Press and hold the UP button and then press a button on the assign row. Button 1 jumps to page 10,
button 8 to page 80, and so forth for all of the buttons.
2. Press and hold the DOWN button and then press a button on the assign row. Button 1 jumps to page 1,
button 12 to page 12, and so forth for all of the buttons.
A quick return to page 1 is also possible by holding the Barco Eye and tapping the down arrow.*
(*) This functionality is not available on the EC-30/EC-50.
12.9 How to use transition buttons
General
Four types of transitional triggering are available:
All Trans
All Trans (Transitions All) is the way to start a timed transition of Destinations. It transitions the set up preview
into program. This function can also be found in the GUI, in the bottom right corner, below the assignment
pane.
In the case a transition is not completed it can be reversed.
A manually started transition can be finished with an All Trans command and an All Trans command can be
finished with the T-bar.
Only selected destinations are affected. Unselected destinations are not affected by the transition.
Cut
Cut transitions the selected destination(s) from preview to program, in a single frame's time, set by the System
Native Rate. This function can also be found in the GUI, in the bottom right corner, below the assignment
pane.
Layer Trans
Layer Trans transitions the selected layer in any Destination, whether the Destination is selected or not. This
button is placed on the right side of the Layers selection bus. It can also be found in the GUI, below the
workspace.
Layer Cut
Layer Cut transitions the selected layer(s) in any Destination, whether the Destination is selected or not. This
button is placed on the right side of the Layers selection bus. It can also be found in the GUI, below the
workspace.
Controller Operation