Barco Event Master E2 Series, Руководство пользователя

Страница: 162 / 584

R5905948 /12 Event Master Devices 162
◦ Minimum delay capable Screen
Destinations that are rotated have 1 frame
of delay.
◦ Non-minimum delay capable Screen
Destinations that are rotated have 2 frames
of delay.
◦ AUX Destinations have 1 frame of delay.
◦ Rotated AUX Destinations have 2 frames of
delay.
- When a Destination is rotated, the canvas is
accordingly resized.
- When a Destination is rotated, the Screen
Destination as a source to a Layer is properly
oriented.
Note: The Output rotation icons are available only
for Output from the Quad DisplayPort 1.2 Output
card, the HDMI 2.0 Output card, and the Tri-
Combo Output card.
• Outputs: Provides a list of the output
configurations assigned to the Destination.
For Aux destinations, only 1 Output configuration
is shown or is allowed to be defined. From this
menu outputs can be deleted or added as in the
output configuration menu.
• Layer (only applicable when Destination is a
Screen). You can assign a size to the Layer: SL
(2K Single Link), DL (Dual Link), or 4K. You can
also make the Layer either a Mixing Layer or a
Single Layer.
The list shows the Layers assigned to this
Destination.
A word about layers
Adding to the general description above about layers, mores specifically a EMP´s Screen Destination has one
fixed mixing layer, its BG. Then there are a number of scaling layers available in the system.
The E2 has 2 banks of 8 mixing layers for a total of 16 mixing layers or 32 single layers (32L). These 16 mixing
layers can be assigned to Destinations, using up to 4 Outputs (1 bank). If a Destination uses Outputs from
both banks, the mixing-layer count is reduced to 8. An E2 Jr. has a single bank of 8 mixing layers for a total of
8 mixing layers or 16 single layers (16L).
An S3 – 4k has two banks of 2 mixing layers each for a total of 4 mixing layers or 8 single layers (8L). These 2
mixing layers can be assigned to Destinations, using up to 4 Outputs (1 bank). If a Destination uses Outputs
from both banks, the mixing-layer count is reduced to 2.
Processor Banks
Mixing Layers Single Layers
E2 2 16 32
E2 Jr. 1 8 16
S3 – 4K 2 4 8
S3 – 4K Jr. 1 2 4
EX NA NA NA
The layer system has been optimized in E2 to allow the maximum available layer count at all times and can
therefore be a bit confusing.
Based on the layer mode (set in the Assign panel of the Screen Destination), the number of available layers
varies. The table below shows the maximum number of single layers for each layer mode.
EM GUI orientation