ATS SuperTrak GEN3, Руководство по эксплуатации и обслуживанию, Страница: 245 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 233
Rev. 9 (12-2021)
9. Clean the top of the section with a soft cloth to remove any debris.
Install an Upper V-Rail - 180 Deg. (800 mm) Section
1. Hold the new upper v-rail horizontally, with the counter-bore side up.
2. Slide the new upper v-rail between the upper v-rails of the adjacent sections.
3. Equally divide the gap between the ends of the upper v-rail.
The gap should be close to 0.5 mm (0.02 in.) on both sides.
4. Install the 0.25 mm (0.01 in.) shims. Restore them to the position you made
note of during the removal procedure.
5. Install the twenty one (21) screws into the top of the upper v-rail, while
keeping the back of the upper v-rail biased to the structure.
6. Reinstall the left and right encoder assemblies.
See Install an Encoder Assembly - Straight and Curved Sections on page
167.
Replace an Upper V-Rail - 90 Deg. Section
Remove an Upper V-Rail - 90 Deg. Section
1. Turn the SuperTrak conveyance platform power disconnect switch to
the OFF position.
2. Lock out and tag hazardous energy.
See Lockout and Tagout Locations on page 12.
3. Remove section’s encoder assemblies as
well as the encoder assemblies on the
adjacent sections.
See Remove an Encoder Assembly -
Straight Section on page 165.
See Remove an Encoder Assembly -
Curved Sections on page 166.