ATS SuperTrak GEN3, Руководство по эксплуатации и обслуживанию, Страница: 189 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 177
Rev. 9 (12-2021)
3. With the metal conduit flush with the
strain relief connectors, tighten the two
(2) strain relief connectors.
4. Feed the required wiring through the metal conduit and connect as required,
then close the sections’ electrical doors.
See Straight Section - Left Coil Driver Board on page 28 and Right Coil Driver
Board on page 31 for connection information.
Replace a Section-to-Section Electrical Interconnect--Flexible
Connection
Remove the existing flexible conduit
1. Turn the SuperTrak conveyance platform power disconnect switch to
the OFF position.
2. Lock out and tag hazardous energy.
See Lockout and Tagout Locations on page 12.
3. Access the interior of the sections by:
• For 180 deg. (500 mm) sections, remove screws and washers from the top
cover of the section, and then lift and remove the top cover.
• For all other types of sections, use a flat head screwdriver to unlock the
locks, and then open the electrical door.
4. Disconnect and remove all wires that run through the flexible conduit.
5. Loosen the strain relief connectors on the bottom of both adjacent sections.
6. Remove the flexible conduit.
Install the replacement flexible conduit
1. If required, remove the existing electrical interconnect as described above.
2. Carefully bend the flexible conduit, so that one end is in each of the adjacent
section’s strain relief connectors.