ATS SuperTrak GEN3, Руководство по эксплуатации и обслуживанию, Страница: 209 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 197
Rev. 9 (12-2021)
Magnet
assembly Visually inspect the magnet assembly for
damage or wear (for example; cracks or
flaking magnet plating). Replace the pallet magnet
assembly.
See
Replace a Pallet Magnet
Assembly on page 205.
Visually inspect the magnet assembly for
dirt or debris. Clean dirt and debris off of the
magnet assembly, using a clean,
soft cloth.
Wipe metal debris to a corner or
edge of the magnet and then pull
it off.
Wheels • Check each flat wheel for vertical and
horizontal movement. A small
amount of vertical play (
≤ 0.5 mm
[ ≤ 0.02 in.]) in the flat wheels is
normal and acceptable. If a flat
wheel does not sit firmly in position,
replace the flat wheel and make sure
that the spacers are present.
• Check each v-wheel for vertical
movement. If the v-wheel does not
sit firmly in position, tighten the
screw at the top of the v-wheel.
See Replace the Pallet Flat
Wheels on page 199, and
Replace the Pallet V-Wheels on
page 201.
Turn each wheel to make sure it moves
freely. Replace any wheels that do not
move freely.
Visually inspect each flat wheel for wear
or damage. Replace any badly damaged
wheels. If a wheel has a groove worn
into it, this may indicate that the flat
wear strips, located on the straight
section or curved section, are pitted. The
flat wear strip may require replacement.
Visually inspect v-wheels. If a wheel is
damaged, make sure the upper v-rail is
not damaged and that it is correctly
aligned. See Replace a Flat Wear Strip on
page 238, Replace the Pallet V-
Wheels on page 201, and
Replace an Upper V-Rail on page
230.
Pallet
Component Inspection Resolution