ATS SuperTrak GEN3, Руководство по эксплуатации и обслуживанию, Страница: 54 / 366

42 SuperTrak™ GEN3 System Operation and Maintenance Manual
Rev. 9 (12-2021)
SuperTrak Conveyance Platform Overview
Power Supply
The power supply is an AC to DC power supply that provides 28VDC to the
SuperTrak conveyance platform for pallet motion. Each power supply is wired to a
control panel. Alternating-current (AC) electrical power is supplied to the power
supply from the control panel by a cable plug.
The required number of power supplies varies depending on the demands of the
specific SuperTrak conveyance platform.
Every power supply has a label affixed to it that indicates the date it was tested
and the initials of the tester. This label verifies that the power supply was
inspected and tested. If this label does not exist or an unauthorized replacement
power supply is used, contact ATS for the correct power supply replacement.
See Power Supply Data Sheet on page 335, and Replace the Main Motor Fuse on
page 173 for additional information.
Servicing an electrical panel that is still connected to its power source
may cause injury or death. Unless directed otherwise, turn the
main
power disconnect switch to the OFF position. Lockout and tagout the
switch before accessing and servicing the electrical panel. Only qualified
electrical technicians should perform service on the electrical panel.
See
Hazardous Energy on page 8 and Lockout and Tagout on page 11.
A
Power supply cabinet
E
Power supply filter
B
AC power input plug
F
Power supply mounting plate
C
Alternate 28 VDC power output
location
G
Power supply mounting brackets
D
Power supply OK signal
H
28 VDC power output location