ATS SuperTrak GEN3, Руководство по эксплуатации и обслуживанию, Страница: 247 / 366

Technician Procedures
SuperTrak™ GEN3 System Operation and Maintenance Manual 235
Rev. 9 (12-2021)
Install an Upper V-Rail - 90 Deg. Section
1. Hold the new upper v-rail horizontally, with the counter-bore side up.
2. Slide the new upper v-rail between the upper v-rails of the adjacent sections.
3. Equally divide the gap between the ends of the upper v-rail.
The gap should be close to 0.5 mm (0.02 in.) on both sides.
4. Install the 0.25 mm (0.01 in.) shims. Restore them to the position you made
note of during the removal procedure.
5. Re-install the fifteen (15) screws into the top of the upper v-rail, while keeping
the back of the upper v-rail biased to the structure.
6. Reinstall the encoder assemblies on the 90 deg. section and adjacent sections.
See Install an Encoder Assembly - Straight and Curved Sections on page
167.
Replace an Upper V-Rail - 180 Deg. (500 mm) Section
Remove an Upper V-Rail - 180 Deg. (500) Section
1. Turn the SuperTrak conveyance platform power disconnect switch to
the OFF position.
2. Lock out and tag hazardous energy.
See Lockout and Tagout Locations on page 12.
3. Remove the upper v-rail from the two (2) adjacent straight sections.
See Remove an Upper V-Rail - 180 Deg. (500) Section on page 235.
4. Remove the left and right encoder assemblies from the 180 deg. section.
See Remove an Encoder Assembly - Curved Sections on page 166.
5. Remove ten (10) screws and ten (10)
washers from the top cover of the 180
deg. section, and then lift and remove the
top cover.