Atek 10002iX, Руководство пользователя, Страница: 147 / 259

User Manual California Instruments
10. If there is not enough range in the full-scale calibration coefficient for either resistive or
inductive portion, it may be necessary to tweak the adjustment pots on the iX controller.
These pots were originally adjusted at the factory and normally do not have to be adjusted
again. The Full Scale calibration coefficients should have enough adjustment range. Double
check the connections and phase measurements if this is not the case to make sure the
measurement readings you get are indeed correct.
If it is necessary to adjust the pots, see Table 6-12 for the corresponding pot designators.
The top cover has to be removed to access these pots. They are located along the top edge
of the 7003-718 controller board.
11. Repeat steps 2 through 10 for phase B and C. (except on single phase only models.)
Phase / Board Assembly # R resistive Xl inductive
Phase A (7003-718-1 / 7003-718-3) R121 R122
Phase B (7003-718-1) R112 R111
Phase C (7003-718-1) R114 R115
Table 6-12: Programmable Z adjustment pots
Definitions:
V
NL
= Measured RMS voltage under no load.
V
L
= Measured RMS voltage under load
I = Measured RMS current.
F = Source frequency (50 Hz).
∆Φ
= Phase angle shift between load and no load conditions. Record phase angle
from phase meter under NL and L condition and determine phase shift.
Formulas to calculate R and L component of output impedance:
R = ( V
NL
* cos(
∆Φ
) - V
L
) / I
X
L
= ( V
NL
* sin(
∆Φ
)) / I
L = X
L
/ (2 * Pi * F)
Table 6-13: Formulas to calculate R and L
NSG 1007 Series II 147