CPS100 SERIES OPERATION MANUAL
SECTION 5:
Entire Contents Copyright
2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual
Page 41 of 231
Refer to the “LIFTING DO’S & DON’TS” chart below before removing any CPS units from its
packaging or re-locating it to a different work area.
Figure 5-2: Lifting Do's and Don'ts Chart
5.2.1
Unpacking CPS106, CPS110, CPS115 and CPS120 Models
The CPS106 through CPS115 are shipped in a cardboard box with protective foam inserts. To
remove these units, one or two persons may be used.
Removal Steps:
1.
Position the carton on a stable flat surface with sufficient clearance.
2.
Make sure the carton is right side up. Top is clearly marked on the side of the
carton.
3.
Know where the unit will be placed before proceeding. Make sure the path between
the carton and the staging area is short and clear of any obstacles.
4.
Use a box cutter to cut the tape that holds the top flaps together. Also, cut the side
tape on the top flaps.
5.
Open all four flaps completely and fold them down along the side of the carton so
they do not interfere with access to the inside of the carton.
6.
Remove the ship kit items from the box and put in a safe place.
