CPS100 SERIES OPERATION MANUAL
SECTION 6:
Entire Contents Copyright
2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual
Page 135 of 231
There are two product classes for the IEC
61000-4-14 test. They are Class 2 and Class
3. (Standard modes) Test levels and
durations for these product classes are
defined by the IEC 61000-4-14 standard.
To select the appropriate product class for
the unit under test, move the cursor to the
“Class =” field and press [Enter]. A drop
down list with product class selections is
displayed.
The following parameters can be edited by
the user as needed:
•
Unom:
Nominal test voltage. Fixed at 230V in standard modes.
•
Frequency:
50Hz or 60Hz in standard modes.
•
Cycle:
Number of loops or cycles. Range is 0 ~ 9999. A 0 value means
infinite loop.
When done, press the Save soft key to save
the IEC 4-14 settings to non-volatile memory.
Note:
If the IEC 4-14 test setting is not
saved, it will be lost when the power
source is turned off.
A visual display of the IEC 4-14 test sequence
is available for pre-viewing the test by
pressing the Diagram soft key.
The preview will pop up in the center of the
IEC 4-14 Test screen. Press [Esc] to clear the
preview.
