Aerotech UNIDEX 600 Series, Руководство пользователя

Страница: 206 / 354

U600 User’s Guide Setup Wizard
Version 1.4
Aerotech, Inc.
12-27
12.11. Configure the DISABLEMASK
This axis parameter determines which faults will cause an axis to be disabled. This
parameter is a bit mask where each bit corresponds to a specific fault. The
DISABLEMASK takes priority over the HALTMASK and ABORTMASK (i.e., if the
DISABLEMASK is set to occur, the HALTMASK or ABORTMASK will have no effect,
because the DISABLEMASK would disable the axis before it could halt or abort).
Each bit set in this parameter should also be set in the FAULTMASK axis parameter, to
enable detection of that fault condition.
Figure 12-19. The DISABLEMASK Configuration Screen
In the screen above, and all subsequent screens in the same format, a grayed
checkbox (such as that for the CW Soft Limit) indicates that the fault condition can
not be checked here because it is not checked (set active) on the FAULTMASK page
(Section 12.10.). If a box is grayed and checked, it will also be inactive on this
screen. It will be ignored unless its corresponding checkbox is also set on the
FAULTMASK page.