Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Руководство по программному обеспечению, Страница: 83 / 233

5-44
container Commands
Command And Switch Availability
This command and its associated switches (if any) are supported on
the following operating systems:
■ Windows NT
■ Windows 2000 (basic disk only)
■ Windows XP (basic disk only)
Syntax
container extend file_system {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the array whose file system
you want to extend.
Examples
Typically, you would use the
container extend file_system
command after adding a level to an array and, perhaps, after
extending a multilevel volume set.
Before extending a file system, use the
container list
command to obtain information about any existing arrays:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
E: 0 Volume 300MB NTFS
63 Volume 100MB 1:00:0 64.0KB: 100MB
62 Volume 100MB 1:01:0 64.0KB: 100MB
61 Volume 100MB 1:02:0 64.0KB: 100MB
The following list describes the sequence that caused the previous
example to display:
1
Create a volume set of 100 MB on disk (1,0,0) with the
container create volume
command.
2
Add a level to the volume set created in Step 1 with the
container add_level
command.