Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Руководство по программному обеспечению, Страница: 141 / 233

5-102
container Commands
container set global_failover
To assign an automatic failover disk(s) for all arrays, use the
container set global_failover
command. If the array was
already assigned a failover disk(s), the command adds the specified
disk(s) to the array’s list of failover disk(s). Although all array types
accept failover assignments, only mirror set and RAID-5 set
(redundant) array types use the failover assignment if a disk fails.
Syntax
container set global_failover {scsi_device}
[{scsi_device}...]
Parameters
{scsi_device}
Specifies the ID for the SCSI device that you want to assign as a
failover disk. The command assigns this disk to all arrays. A
SCSI ID consists of a SCSI channel number (for example, 0, 1, 2,
3, etc.), a SCSI device ID (0 through 15 inclusive), and a SCSI
device logical unit number (0 through 7 inclusive). See the
scsi_device
section on page 3-7 for more information on
how to specify the SCSI device.
{scsi_device}...
Specifies the ID(s) for additional SCSI device(s) that you want
to assign as failover disk(s) to all arrays.
Examples
Before assigning a SCSI device as a failover disk to all arrays, use the
container list
command to obtain information about any
existing arrays. As the following example shows, there is an array 0
(a mirror set) on this controller:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Mirror 15.0MB None 1:02:0 64.0KB: 15.0MB
Tigris 1:03:0 64.0KB: 15.0MB