Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Руководство по программному обеспечению, Страница: 69 / 233

5-30
container Commands
container create stripe
To create a stripe set from freespace, use the
container create
stripe
command.
Notes
If you created a stripe set you can run the
list devices
command on the NetWare console to verify its creation and then
create the necessary NetWare disk partitions and volumes.
For information on how to create partitions and volumes, see the
appropriate NetWare documentation.
Syntax
container create stripe [/cache{=boolean}]
[/stripe_size{=integer}] [/label{=string}]
{free_space} [{scsi_device}...]
Parameters
{free_space}
Specifies the SCSI device and its associated freespace used to
create the stripe set. See the
free_space
section on page 3-8
for more information on how to specify the freespace.
{scsi_device}...
Specifies one or more devices. A SCSI ID consists of a SCSI bus
number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through 15
inclusive), and SCSI device logical unit number (0 through 7
inclusive). See the installation guide for your controller to
determine the number of buses it actually supports.
See the
scsi_device
section on page 3-7 for more
information on how to specify the SCSI device. The command
uses the freespace(s) from the SCSI device(s) to create the stripe
set. The size from the device is identical to the one you specify
in the
free_space
parameter.
The minimum number of partitions for a stripe set is 2, and the
maximum number is 16.