Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Руководство по программному обеспечению, Страница: 44 / 233

5-5
container Commands
container create mirror
To create a mirror set from a single-partition volume set and
freespace, use the
container create mirror
command. Any
data on the original volume set remains intact during mirror
creation and the user sees no interruption in service.
If you created a mirror set on a NetWare server, you can run the
list devices
command on the NetWare console to verify its
creation and then create the necessary NetWare disk partitions and
volumes.
For information on how to create partitions and volumes, see the
appropriate NetWare documentation.
Syntax
container create mirror [/wait{=boolean}]
[/io_delay{=integer}] {container} {scsi_device}
Parameters
{container}
Specifies the ID number (0 to 63) of the array on which to
create a mirror set. You create a mirror set from a single-
partition volume set.
{scsi_device}
Specifies the ID for the SCSI device whose freespace you want
to use for mirroring the volume set specified in the container
parameter. A SCSI ID consists of a SCSI bus number (e.g., 0, 1,
2, 3, etc.), SCSI device ID (0 through 15 inclusive), and SCSI
device logical unit number (0 through 7 inclusive). See the
installation guide for your controller to determine the number
of buses it actually supports.
See the
scsi_device
section on page 3-7 for more
information on how to specify the SCSI device.