Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Руководство по программному обеспечению, Страница: 59 / 233

5-20
container Commands
{container}...
Specifies the ID (0 to 63) of one or more additional arrays from
which you want to create the multilevel volume set. You can
use up to 16 arrays. Typically, the additional arrays you specify
are the same type as the first array. For example, if the first
array is a stripe set then any subsequent arrays are also stripe
sets.
Switches
/label{=string}
Specifies a label to be assigned to the newly created multilevel
volume set. You can specify a maximum of sixteen characters
for the label.
If you do not specify the switch, it defaults to no label. If you
do not specify a label, you can do so later by using the
container set label
command.
Examples
Before creating a multilevel volume set, use the
container list
command to obtain information about any existing arrays.
As the following example shows, there are two existing arrays
(stripe sets) on this controller at the time the multilevel volume set is
created:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Stripe 45MB 64KB None 0:02:0 64.0KB: 15.0MB
0:03:0 64.0KB: 15.0MB
0:04:0 64.0KB: 15.0MB
1 Stripe 15MB 64KB None 0:05:0 64.0KB: 15.0MB