Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Руководство по программному обеспечению, Страница: 127 / 233

5-88
container Commands
container remove file_system
To remove the file system from an array, use the
container
remove file_system
command. Use this command when the file
system on the array is no longer needed.
This command fails if there are open files on the array.
Command Availability
This command and its associated switches (if any) are supported on
the following operating systems:
■ Windows NT
■ Windows 2000 (basic disk only)
■ Windows XP (basic disk only)
Syntax
container remove file_system {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the array from which you
want to remove the file system.
Examples
Before removing a file system from an array, use the
container
list
command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller:
AAC0>container list
Executing: container list
Num Total Oth Stripe Scsi Partition
Dr Label Type Size Ctr Size Usage C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 10.0MB NTFS 0:02:0 64.0KB: 10.0MB