Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Руководство по программному обеспечению, Страница: 139 / 233

5-100
container Commands
container set failover
To assign an automatic failover disk(s) for a single array, use the
container set failover
command. If the array was already
assigned a failover disk(s), the command adds the specified disk(s)
to the array’s list of failover disk(s). Although all array types accept
failover assignments, only mirror set and RAID-5 set (redundant)
array types use the failover assignment if a disk fails.
Syntax
container set failover {container} {scsi_device}
[{scsi_device}...]
Parameters
{container}
Specifies the ID number (0 to 63) of the array on which to
assign an automatic failover disk(s).
{scsi_device}
Specifies the ID for the SCSI device that you want to assign as a
failover disk to the array specified in the
container
parameter.
A SCSI ID consists of a SCSI channel number (for example, 0, 1,
2, 3, etc.), a SCSI device ID (0 through 15 inclusive), and a SCSI
device logical unit number (0 through 7 inclusive). See the
scsi_device
section on page 3-7 for more information on
how to specify the SCSI device.
{scsi_device}...
Specifies the ID(s) for additional SCSI device(s) that you want
to assign as failover disk(s) to the array specified in the
container
parameter.
Examples
Before assigning a SCSI device as a failover disk to an array, use the
container list
command to obtain information about any
existing arrays.