Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Руководство по программному обеспечению, Страница: 195 / 233

7-11
disk Commands
disk set default
To set the default SCSI ID for use in subsequent CLI commands, use
the
disk set default
command. This command allows you to
set defaults for a specific device’s channel number and device logical
unit number. Then, in subsequent commands, you need only specify
the device ID on the command line.
Syntax
disk set default {scsi_device}
Parameters
{scsi_device}
Specifies the ID for the device. A SCSI ID consists of a SCSI
channel number (for example, 0, 1, 2, 3, etc.), a device ID (0
through 15 inclusive), and a device logical unit number (0
through 7 inclusive). See the
scsi_device
section on
page 3-7 for more information on how to specify the SCSI
device.
If you do not specify a device ID, the command displays an
appropriate error message.
Examples
The following example sets the SCSI channel number and SCSI
default logical unit number for device (0,3,0) as the default for use in
subsequent CLI commands:
AAC0>disk set default (1,3,0)
Executing: disk set default (CHANNEL=1,ID=3,LUN=0)
You need only specify the device ID in subsequent CLI commands,
and the CLI assumes the default SCSI channel number and SCSI
logical unit number as follows:
AAC0>disk list 3
Executing: disk list (ID=3)
C:ID:L Device Type Blocks Bytes/Block Usage Shared
------ ----------- --------- --------- -------------- ------
2:03:0 Disk 4197405 512 Initialized NO
See the
disk list
command for information on the items in the
display.