Adaptec 2254100-R - SATA RAID 2410SA SGL/64 Controller, Руководство по программному обеспечению, Страница: 68 / 233

5-29
container Commands
■
The Type column displays RAID-5 to indicate that the newly
created array is a RAID-5 set.
■
The Total Size column displays the total size of the freespace
available. In this example, 40.0 MB of freespace was specified,
which means that this column displays 30.0 MB as available.
■
The Stripe Size column displays the stripe size you specified
as the
stripe_size
parameter, which in the example is 64
KB.
■
The Usage column displays None to indicate that the newly
created RAID-5 set does not have a file system on it.To create
an NTFS or FAT file system on an array, use the
container
format
command.
■
The State column displays the state of an array, which in the
example shows Unprot to indicate that the RAID-5 set is not
yet redundant. This means that the command has not
completed the creation of the RAID-5 set. If the
container
list
command is executed after the RAID-5 set completes
execution, the State column is blank.
(Note that this column appears only if you specify the
/full
switch
with the
container list
command.)
■
The Scsi C:ID:L column displays the SCSI device ID(s) for the
disk(s) on which you created the RAID-5 set, which in the
example are: 0:02:0, 0:03:0, 0:04:0, and 0:05:0.
■
The Partition Offset: Size column displays the partition
offset(s) and size(s) of the newly created RAID-5 set, which in
the example is 64.0 KB and 10.0 MB respectively.
Related Information
container
commands:
■
container list
( page 5-54 )
■
container set cache
( page 5-97 )
■
container set label
( page 5-107 )