ABB CRB 1300, Руководство по эксплуатации продукта

Страница: 170 / 726

4.3 Cleaning activities
4.3.1 Cleaning the CRB 1300
General
To secure high uptime it is important that the CRB 1300 is cleaned regularly. The
frequency of cleaning depends on the environment in which the manipulator works.
Different cleaning methods are allowed depending on the type of protection of the
CRB 1300.
Note
Always verify the protection type of the robot before cleaning.
WARNING
Turn off all electrical power supplies to the robot before starting the cleaning.
Special cleaning considerations
This section specifies some special considerations when cleaning the robot.
• Always use cleaning equipment as specified. Any other cleaning equipment
may shorten the life of the robot.
• Always check that all protective covers are fitted to the robot before cleaning.
• Do not point the water jet at connectors, joints, sealings or gaskets.
• Do not use compressed air to clean the robot.
• Do not use solvents that are not approved by ABB to clean the robot.
• Do not remove any covers or other protective devices before cleaning the
robot.
Cleaning methods
This following table defines what cleaning methods are allowed for ABB
manipulators depending on the protection type.
Cleaning method Protection
type
High pressure water,
steam or spray Rinse with water Wipe with cloth Vacuum
cleaner
No Yes. It's highly re-
commended to in-
spect the fans for
contamination that
could hinder the air
supply at the regu-
lar cleaning, and
then clean if neces-
sary. Yes. With light
cleaning deter-
gent. Yes Standard
Continues on next page
170 Product manual - CRB 1300
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
4 Maintenance
4.3.1 Cleaning the CRB 1300