Chapter 5 WAN/Internet
SBG5500 Series User’s Guide
64
The following table describes the fields in this screen.
ADSL over ATM
If you select
ADSL over ATM
as the interface type, the following screen appears.
Table 11 WAN / Internet > WAN Setup > Add/Edit: Bridge Mode (ADSL/VDSL over PTM or Ethernet)
LABEL
DESCRIPTION
General
Interface Enable Select this to activate the WAN configuration settings.
Name
Enter a service name of the connection.
Type
Select
ADSL/VDSL over PTM
as the interface that you want to configure. The SBG uses the VDSL
technology for data transmission over the DSL port. Otherwise, select
Ethernet
to have the SBG
transmits data over the Ethernet WAN port.
Mode
Select
Bridge
when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP’s DHCP server directly. If you select
Bridge
, you cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic
from the selected LAN port(s).
VLAN
Enable
Select this to add the VLAN Tag (specified below) to the outgoing traffic through this
connection.
802.1p
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that
contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The
greater the number, the higher the priority level.
VLAN ID
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
WAN MAC Address
Factory Default
Select this to use the factory default MAC address,
Clone the
Computer MAC
address-IP
Address
Select this to clone the MAC address from a computer on your LAN. Type the
IP address
of the
computer with the MAC address you are cloning.
Set MAC
address
Select this if you know the MAC address you want to use.
OK
Click
OK
to save your changes.
Cancel
Click
Cancel
to exit this screen without saving.
Summary of Contents for SBG5500-A
Page 12: ...12 PART I User s Guide...
Page 44: ...44 PART II Technical Reference...
