Chapter 7 Routing
SBG5500 Series User’s Guide
121
Figure 93
Configuration > Routing > RIP
The following table describes the labels in this screen.
Table 41 Configuration > Routing > RIP
LABEL
DESCRIPTION
#
This is the index number of the entry.
Interface
This is the name of the interface in which the RIP setting is used.
Version
The RIP version controls the format and the broadcasting method of the RIP packets that the
SBG sends (it recognizes both formats when receiving). RIP version
RIPv1
is universally
supported but RIP version
RIPv2
carries more information. RIP version
RIPv1
is probably
adequate for most networks, unless you have an unusual network topology.
Operation
Select
Passive
to have the SBG update the routing table based on the RIP packets received
from neighbors but not advertise its route information to other routers in this interface.
Select
Active
to have the SBG advertise its route information and also listen for routing
updates from neighboring routers.
Enabled
Select the check box to activate the settings.
Routing Rule List
This shows the destination IP address and subnet mask of the routing entries.
Deny
Select the check box to deny routing entries to report (send out) through the interfaces.
Apply
Click
Apply
to save your changes.
Cancel
Click
Cancel
to exit this screen without saving.
Summary of Contents for SBG5500-A
Page 12: ...12 PART I User s Guide...
Page 44: ...44 PART II Technical Reference...
