Chapter 11 Bandwidth Management
SBG5500 Series User’s Guide
207
11.6.1 Add/Edit a QoS Shaper
Click
Add
in the
Shaper Setup
screen or select a shaper and click
Edit
to show the following screen.
Figure 151
Shaper Setup: Add/Edit
The following table describes the labels in this screen.
11.7 Technical Reference
The following section contains additional technical information about the SBG features described in this
chapter.
IEEE 802.1Q Tag
The IEEE 802.1Q standard defines an explicit VLAN tag in the MAC header to identify the VLAN
membership of a frame across bridges. A VLAN tag includes the 12-bit VLAN ID and 3-bit user priority.
Multiple Entries Turn On
Select one or more shapers and click this
to enable them.
Multiple Entries Turn Off
Select one or more shapers and click this
to disable them.
#
This is the index number of the entry.
Status
This field displays whether the shaper is active or not. A green
ON
button signifies that
this shaper is active. A gray
OFF
button signifies that this shaper is not active.
Click the slide button to turn on or turn off the shaper.
Outgoing Interface
This shows the name of the SBG’s interface through which traffic in this shaper
applies.
Rate Limit (kbps)
This shows the average rate limit of traffic bursts for this shaper.
Table 91 Configuration > Bandwidth Management > Shaper Setup
LABEL
DESCRIPTION
Table 92 Shaper Setup: Add/Edit
LABEL
DESCRIPTION
Enable
Select the check box to activate this shaper.
Outgoing Interface
Select the SBG’s interface through which traffic in this shaper applies.
Rate Limit
Enter the average rate limit of traffic bursts for this shaper.
OK
Click this button to save your changes to the SBG.
Cancel
Click this button to exit this screen without saving.
Summary of Contents for SBG5500-A
Page 12: ...12 PART I User s Guide...
Page 44: ...44 PART II Technical Reference...
